Kia Forte: Oil Cooler Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Hydraulic System / Oil Cooler Inspection
Radiator Cap Testing
| 1. |
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
|
| 2. |
Apply a pressure of 93.16 ~ 122.58 kPa (0.95 ~ 1.25 kgf/cm², 13.51
~ 17.78 psi).
|
| 3. |
Check for a drop in pressure.
|
| 4. |
If the pressure drops, replace the cap.
|
Radiator Leakage Test
| 1. |
Wait until engine is cool, then carefully remove the radiator
cap and fill the radiator with engine coolant, then install it on the
pressure tester.
|
| 2. |
Apply a pressure tester to the radiator and apply a pressure of
93.16 ~ 122.58kpa (0.95 ~ 1.25kg/cm², 13.51 ~ 17.78psi).
|
| 3. |
Inspect for engine coolant leaks and a drop in pressure.
|
| 4. |
Remove the tester and reinstall the radiator cap.
|
Oil Cooler Removal and Installation
1.
Remove the cooling fan.
(Refer to Cooling System - "Cooling Fan")
2.
Remove the radiator upper hose (A).
...
Oil Pump Description
The oil pump is built-in as a single unit with the 26 Brake chamber. Rotation
of the pump builds the hydraulic pressure needed for the lubrication of the
various parts of the transaxle and op ...
See also:
Tail Gate Trim Component Location
(5Door)
1. Tail gate trim
...
Inspection (With GDS)
1.
Check BCM input/output specification of multifunction switch using
the GDS. If the specification is abnormal, replace the lamp or wiper
switch.
...
Control Shaft Complete Removal
1.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
2.
Remove the battery and battery tray ...
Copyright © www.kifomanual.com 2014-2025