Kia Optima Manuals

Kia Forte: Oil Pump Removal and Installation - Lubrication System - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Oil Pump Removal and Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Lubrication System / Oil Pump Removal and Installation

1.
Remove the timing chain cover.
(Refer to Timing System – “Timing Chain Cover”)
2.
Remove the oil pump cover (A).
Tightening torque
Screws :
5.9 ~ 8.8 N.m (0.6 ~ 0.9 kgf.m, 4.3 ~ 6.5 lb-ft)
Bolts :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

3.
Remove the inner rotor (A) and outer rotor (B).
4.
Install in the reverse order of removal.
Oil Pump Components
1. Inner roter 2. Outer roter 3. Oil pump cover 4. Relief plunger 5. Relief spring 6. Relief plug 7. O-ring (suction side) 8. O-ring (discharge side) ...

Oil Pump Inspection
1. Remove the relief plunger. Remove the plug (A), spring (B) and relief plunger (C). Tightening torque Plug (A) : ...

See also:

Tire pressure monitoring system
...

Variable Charge Motion Actuator (VCMA) Description
The Variable Charge Motion Actuator (VCMA) is installed on the inlet of the intake manifold. It consists of a DC motor which actuates the VCM valve and a position sensor which detects th ...

Rear Torsion Beam Axle Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Categories

Copyright www.kifomanual.com 2014-2026