Kia Optima Manuals

Kia Forte: Receiver-Drier Replacement - Air Conditioning System - Heating,Ventilation, Air Conditioning - Kia Forte TD 2014-2018 Service ManualKia Forte: Receiver-Drier Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Air Conditioning System / Receiver-Drier Replacement

1.
Remove the condenser, and then remove the bottom cap (B) with a L wrench (A) from the condenser.
Tightening torque :
9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8lb-ft)

2.
Remove the receiver-drier (A) from condenser using a long nose plier. Check for crumbled receiver-drier and clogged bottom cap filter.
3.
Apply air conditioning compressor oil along the O-rings and threads of the new bottom cap.
4.
Insert a new receiver-drier into the receiver drier tank. The receiver-drier must be sealed in vacuum before it is exposed to air for use.
5.
Install the new bottom cap to the condenser.
  
•
Always replace the receiver-drier and bottom cap at the same time.
•
Replace the O-rings with new ones at each fitting, and apply a thin coat of refrigerant oil before installing them. Be sure to use the right O-rings for R-134a to avoid leakage.
•
Be careful not to damage the radiator and condenser fins when installing the condenser.
•
Be sure to install the lower mount cushions of condenser securely into the holes.
•
Charge the system, and test its performance.
Condenser Replacement
1. Recover the refrigerant with a recovery/ recycling/ charging station. 2. Disconnect the negative (-) battery terminal. 3 ...

A/C Pressure Transducer Description
The A/C Pressure Transducer (APT) converts the pressure value of high pressure line into voltage value after measuring it. By converted voltage value, engine ECU controls the cooling fan by o ...

See also:

Tilt and telescoping steering
Tilt steering allows you to adjust the steering wheel before you drive. You can also raise it to give your legs more room when you exit and enter the vehicle. The steering wheel should be positioned ...

Engine Room Under Cover Removal and Installation
1. Remove the under cover front panel (A). 2. Remove the under covers (B). Tightening torque: 3.9 ~ 5.9 N ...

EBD(Electronic Brake-force Distribution)
The EBD system (Electronic Brake force Distribution) as a sub-system of the ABS system is to control the effective adhesion utilization by the rear wheels. It further utilizes the efficie ...

Categories

Copyright www.kifomanual.com 2014-2026