Kia Forte: Relay Box (Engine Compartment) Inspection - Fuses And Relays - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Relay Box (Engine Compartment) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Fuses And Relays / Relay Box (Engine Compartment) Inspection

Power Relay Test (Type A)
  
-
Do not use pliers.
-
Pliers will damage the relays, which could cause the engine to stall or not start.
-
Carefully remove the relay using the relay puller.
Check for continuity between the terminals.
A. C/Fan 1 relay
B. C/Fan 2 relay
C. SSB 4(IG2) relay
D. Blower relay
E. Rear defogger relay
F. Horn relay
G. SSB2(ACC) relay
H. Start 1 relay
I. SSB3(IG1) relay
J. PTC relay

1.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
2.
There should be no continuity between the No.30 and No.87 terminals when power is disconnected.

Power Relay Test (Type B)
Check for continuity between the terminals.
A : Wiper relay
1.
There should be continuity between the No.30 and No.87 terminals when power and ground are connected to the No.85 and No.86 terminals.
2.
There should be continuity between the No.30 and No.87 terminals when power is disconnected.

Replacement of EMS box
1.
Disconnect the negative(-) battery terminal.
2.
Push 3 hooks in the engine room relay box out to the arrow direction and put up the EMS box assembly(A).

3.
Disconnect the connector and remove the EMS box assembly(A).

Fuse Inspection
1.
Be sure there is no play in the fuse holders, and that the fuses are held securely.
2.
Are the fuse capacities for each circuit correct?
3.
Are there any blown fuses?
  
If a fuse is to be replaced, be sure to use a new fuse of the same capacity. Always determine why the fuse blew first and completely eliminate the problem before installing a new fuse.
Multi Fuse
Multi Fuse is for optimizing the engine room package.

  
-
Multi fuse has to replace entirely when there is damage to only one fuse.
-
When replace the multi fuse, refer to the "Engine compartment - component location" diagram exactly.
-
Use the multi fuse capacities for each circuit correctly.
Relay Box (Engine Compartment) Components
...

Relay Box (Passenger Compartment) Components
...

See also:

Fuel Tank Pressure Sensor (FTPS) Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Front Door Belt Inside Weatherstrip Replacement
1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Remove the front door belt inside weatherstrip (A ...

Fuel Filler Cap Description
A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler ...

Copyright � www.kifomanual.com 2014-2026