Kia Optima Manuals

Kia Forte: Tail Gate Assembly Replacement - Tail Gate - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Tail Gate Assembly Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Assembly Replacement

(5Door)
  
•
Wear gloves to protect hands from injury.
  
•
When removing and installing the tail gate, an assistant is necessary.
1.
Remove the tail gate upper trim.
(Refer to Tail Gate - "Tail Gate Trim")
2.
Remove the tail gate trim.
(Refer to Tail Gate - "Tail Gate Trim")
3.
Remove the tail gate side trim.
(Refer to Tail Gate - "Tail Gate Trim")
4.
Disconnect the washer nozzle hose (A) and high mounted stop lamp connector (B).
5.
Disconnect the connectors and tail gate wiring harness (A).
6.
After loosening the mounting bolts, then remove the tail gate assembly (B).
Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

7.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the tail gate lifter (B).
8.
Install in the reverse order of removal.
  
•
Make sure the tail gate locks/unlocks and opens/closes properly.
•
Adjust the tail gate alignment.
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips.
Tail Gate Assembly Component Location
(5Door) 1. Tail gate assembly ...

Tail Gate Trim Component Location
(5Door) 1. Tail gate trim ...

See also:

Specification
Ignition System Ignition Coil Item Specification Primary Coil Resistance (Ω) 0.75 ± 15％ [20°C (68°F)] Secondary Coil Re ...

Removal
1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Pull the passenger seat towards the front till the end. ...

Rear Coil Spring Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from f ...

Categories

Copyright www.kifomanual.com 2014-2026