Kia Forte: 26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: 26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Circuit Diagram

26 Brake Control Solenoid Valve(26/B_VFS) Specifications
Direct control VFS[26/B] ▷ Control type : Normal low type Control Pressure kpa (kgf/cm², psi) 9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54) Current value(mA) ...

26 Brake Control Solenoid Valve(26/B_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

See also:

Engine Control Module (ECM) Installation
   When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...

Ignition Coil Specification
Item Specification Primary Coil Resistance (Ω) 0.75 ± 15% [20°C (68°F)] Secondary Coil Resistance (kΩ) 5.9 ± 15% [20°C ( ...

Receiver-Drier Replacement
1. Remove the condenser, and then remove the bottom cap (B) with a L wrench (A) from the condenser. Tightening torque : 9.8~14.7N.m ( ...

Copyright © www.kifomanual.com 2014-2018