Kia Forte: 26 Brake Control Solenoid Valve(26/B_VFS) Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: 26 Brake Control Solenoid Valve(26/B_VFS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / 26 Brake Control Solenoid Valve(26/B_VFS) Removal

  
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly. (Refer to "Valve Body" in this group)
26 Brake Control Solenoid Valve(26/B_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Line Pressure Control Solenoid Valve Description
line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...

See also:

Alternator On-vehicle Inpection
   • Check that the battery cables are connected to the correct terminals. ...

Service Standard
Item Specification Ignition Timing (°) BTDC 5 ± 10 Idle Speed (rpm) A/C OFF Neutral, N, P-range 640 ± 100 D-range ...

ETC (Electronic Throttle Control) System Description
The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Acc ...

Copyright www.kifomanual.com 2014-2026