Kia Forte: Accelerator Position Sensor (APS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Removal

1.	Turn the ignition switch OFF and disconnect the negative (-) battery cable.

2.	Disconnect the accelerator position sensor connector (A).

3.	Remove the installation bolt (B), the nuts (C) and then remove the accelerator pedal module.

Accelerator Position Sensor (APS) Inspection

1. Connect the GDS on the Data Link Connector (DLC). 2. Turn the ignition switch ON. 3. Measure the output volt ...

Accelerator Position Sensor (APS) Installation

1. Install in the reverse order of removal. Accelerator pedal module installation nut: 12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...

See also:

Manual transaxle operation
The manual transaxle has 6 forward gears. This shift pattern is imprinted on the shift knob. The transaxle is fully synchronized in all forward gears so shifting to either a higher or a lower ge ...

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the evaporator temperature sensor connector (A). 3. ...

ETC (Electronic Throttle Control) System Fail-Safe Mode
Item Fail-Safe ETC Motor Throttle valve stuck at 7° TPS TPS 1 fault Replace it with TPS 2 TPS 2 fault Replace it with ...

Categories

Copyright � www.kifomanual.com 2014-2026