Kia Forte: Accelerator Position Sensor (APS) Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Accelerator Position Sensor (APS) Installation
| 1. |
Install in the reverse order of removal.
|
Accelerator Position Sensor (APS) Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the accelerator position sensor connector (A). ...
Fuel Tank Pressure Sensor (FTPS) Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge control solen ...
See also:
Power Mosfet Inspection
1.
Turn the ignition switch ON.
2.
Manually operate the control switch and measure the voltage of
the blower motor.
3. ...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable from battery and wait for
at least thirty seconds bef ...
Removal
1.
Remove the mirror wiring cover (A).
2.
Disconnect the mirror connector (B).
3.
Loosen the mirror mou ...
Copyright © www.kifomanual.com 2014-2025