Kia Optima Manuals

Kia Forte: Adjustment - Sunroof - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Adjustment

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Sunroof / Adjustment

How To Initialize
1.
Check that the glass has been installed.
A.
Finished height adjustment.
2.
Push the UP switch. (Keep on pushing the switch)

3.
Release the sunroof UP button with in 15 seconds. And then press and hold the UP button once again within 15 seconds until the sunroof do as follows.
A.
Tilt up → Slide Open → Slide Close
4.
Then release the lever.
5.
When the sunroof is closed completely, turn OFF the UP switch initialize the motor completely.
When To Initialize The Motor
1.
After initial vehicle assembly.
2.
If the initial value is erased or damaged because of short power electric discharge during operation.
3.
After using the manual handle.
Operating The Sunroof Emergency Handle
1.
Use the sunroof emergency handle to close or open the sunroof manually if the sunroof cannot be closed electronically due to motor or controller electrical malfunction.
2.
Operating method.
A.
Remove the roof trim.
B.
Push the emergency handle up into the hexagonal drive (A) of the sunroof motor. You must push hard enough to disengage the motor clutch; otherwise the emergency handle will slip due to incomplete fit in the motor.
C.
Carefully turn the emergency handle clockwise to close the sunroof.
D.
After closing the sunroof, wiggle the handle back and forth as you remove the tool from the motor, to ensure the motor clutch reengages.
E.
A 5mm hex socket may be used in place of the emergency handle, with a” Speeder” type handle.
  
•
Do not use power tools to operate the sunroof.
•
Damage to the components may occur.

Components
1. Glass panel assembly 2. Guide assembly 3. Drip rail assembly 4. Sunshade assembly 5. Deflector 6. Deflector link assembly 7. Sunroof frame assembly 8. Motor asse ...

Sunroof Glass Component Location
1. Sunroof glass ...

See also:

Purge Control Solenoid Valve (PCSV) Description
Purge Control Solenoid Valve (PCSV) is installed on the intake manifold and controls the evaporative purge between the canister and the intake manifold. It is a normally closed solenoid valve ...

SRS Control Module (SRSCM)
The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The ...

Power Window Motor Inspection
Front Power Window Motor Inspection 1. Remove the front door trim. (Refer to Body - "Front Door Trim") 2. Disconnect the c ...

Categories

Copyright www.kifomanual.com 2014-2026