Kia Forte: Alternator Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Alternator Removal

1.	Disconnect the battery negative (-) cable.

2.	Remove the drive belt. (Refer to Engine Mechanical System - "Timing Chain")

3.

Disconnect the alternator connector (A) and the cable from the alternator "B" terminal (B).

Tightening torque :

9.8 ~ 14.7 N.m (1.0 ~ 1.5 kgf.m, 7.2 ~ 10.9 lb-ft)

4.

Remove the alternator (A) after removing the bolts.

Tightening torque :

[12 mm bolt] 21.6 ~ 32.4 N.m (2.2 ~ 3.3 kgf.m, 15.9 ~ 23.9 lb-ft)

[14 mm bolt] 29.4 ~ 41.2 Nm (3.0 ~ 4.2 kgf.m, 21.7 ~ 30.4 Ib-ft)

Alternator On-vehicle Inpection

â€¢ Check that the battery cables are connected to the correct terminals. ...

Alternator Intallation

1. Install in the reverse order of removal. Adjust the alternator belt te ...

See also:

Adjustment
Transaxle Control Module(TCM) Learning When shift shock is occurred or parts related with the transaxle are replaced, TCM learning should be performed. In the following case, TC ...

Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be between MAX and MIN marks on the side of the reservoir. Before removing the reservoir cap and adding brake/clutch* ...

Hood Latch Replacement
1. Disconnect the hood latch connector (A). 2. Remove the hood latch assembly (A) mounting bolts. Tightening ...

Categories

Copyright © www.kifomanual.com 2014-2026