Kia Forte: ISG (Idle Stop & Go) System
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System
- Description
- Operation
- Operation Condition for the ISG function
- Components Location
- Battery Sensor Description
- Brake Booster Vacuum Pressure Sensor Description
- Brake Booster Vacuum Pressure Sensor Circuit Diagram
- Brake Booster Vacuum Pressure Sensor Inspection
- Brake Booster Vacuum Pressure Sensor Removal
- Brake Booster Vacuum Pressure Sensor Installation
- AGM Battery Description
- AGM Battery Specification
- AGM Battery Adjustment
- AGM Battery Removal
- AGM Battery Installation
- AGM Battery Inspection
- AGM Battery Cleaning
- DC/DC Converter Description
- DC/DC Converter Operation Principle
- DC/DC Converter Component Location
- DC/DC Converter Circuit Diagram
- DC/DC Converter Removal
- DC/DC Converter Installation
- ISG OFF Switch Description
- ISG OFF Switch Inspection
- Alternator Description
- Alternator Specification
- Alternator On-vehicle Inpection
- Alternator Removal
- Alternator Intallation
- Starter Description
- Starter Removal
- Starter Installation
- Electric Oil Pump Description
- Electric Oil Pump Circuit Diagram
- Electric Oil Pump Removal
- Electric Oil Pump Installation
- Oil Pump Unit (OPU) Connector
- Oil Pump Unit (OPU) Circuit diagram
- Oil Pump Unit (OPU) Removal
- Oil Pump Unit (OPU) Installation
- Oil Pump Unit (OPU) Inspection
- Brake Switch Description
- Brake Switch Inspection
- Brake Switch Removal
- Brake Switch Installation
- Door Switch Description
- Door Switch Inspection
- Door Switch Removal
- Door Switch Installation
- Seat Belt Switch Description
- Seat Belt Switch Inspection
- Seat Belt Switch Removal
- Seat Belt Switch Installation
- Hood switch Description
- Hood switch Inspection
Variable Charge Motion Actuator (VCMA) Installation
•
Install the component with the specified torques.
•
...
Description
Idle Stop & Go (ISG) function automatically switches off the engine when
the car is at a standstill if the and starts it again as soon as the brake pedal
is released. This not only reduce ...
See also:
Component Location
1. Start Stop Button(SSB)
2. FOB key
3. Smart key unit
4. Interior antenna
5. Trunk antenna
6. Door handle & door antenna
7. Bumper antenna
8. Trunk lid open sw ...
Thermostat Components
1. Water inlet fitting
2. Thermostat
3. Bypass hose
4. Heater pipe & hose assembly
...
Door Switch Inspection
1.
Remove the door switch and check for continuity between the terminals.
...
Copyright © www.kifomanual.com 2014-2025