Kia Forte: Seat Belt Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Seat Belt Switch Removal
| 1. |
Remove the front seat.
|
| 2. |
After loosening the mounting bolt, then remove the front seat
belt buckle (A).
|
Seat Belt Switch Inspection
1.
Remove the connector from the switch.
2.
Check for continuity between terminals.
Seat belt condition
Continu ...
Seat Belt Switch Installation
1.
Install in the reverse of removal.
...
See also:
Front Cross Member
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
...
Door Scuff Trim Component Location
(4Door, 5Door)
1. Front door scuff trim
2. Rear door scuff trim
(2Door)
1. Front door scuff trim
...
Fuses
A vehicle's electrical system is protected from electrical overload damage by
fuses.
This vehicle has 2 fuse panels, one located in the driver's side panel bolster,
others in the engine ...
Copyright © www.kifomanual.com 2014-2024