Kia Forte: SS-A Solenoid Valve(ON/OFF) Description - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2019 Service ManualKia Forte: SS-A Solenoid Valve(ON/OFF) Description

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / SS-A Solenoid Valve(ON/OFF) Description

Shift Solenoid(SS) Valve-A is attached to the valve body and is an on/off solenoid valve that is used to change gears. Shift Solenoid(SS) Valve-A is installed at valve body.

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Removal
   Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the ...

SS-A Solenoid Valve(ON/OFF) Specifications
ON/OFF Solenoid Valve(SS-A, SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12)  Internal resistance(Ω ...

See also:

Installation
1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least thirty seconds. ...

Input Speed Sensor Inspection
1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

Component Replacement After Deployment
   Before doing any SRS repairs, use the GDS Pro to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing ...

Copyright © www.kifomanual.com 2014-2019