Kia Forte: Brake Switch Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / ISG (Idle Stop & Go) System / Brake Switch Removal
| 1. |
Turn ignition switch OFF.
|
| 2. |
Remove the crash pad lower panel. (Refer to the Body group-"crash
pad")
|
| 3. |
Disconnect the stop lamp switch connector (A).
|
Brake Switch Inspection
1.
Connect a circuit tester to the connector of stop lamp switch,
and check whether or not there is continuity when the plunger of the
stop lamp switch is pushed in an ...
Brake Switch Installation
1.
Install in reverse of removal.
...
See also:
Control Cable Adjustment
Select cable adjustment
1.
Remove the select cable snap pin (A) and then remove the select
cable (B) from the shift lever pin.
2.
...
ESC OFF Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad side switch assembly (A).
3.
D ...
Component Location
1. Sunroof
2. Sunroof switch
3. Sunroof motor & controller
...
Copyright © www.kifomanual.com 2014-2025