Kia Forte: Audio Remote Control Removal - Audio - Body Electrical System - Kia Forte TD 2014-2019 Service ManualKia Forte: Audio Remote Control Removal

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Body Electrical System / Audio / Audio Remote Control Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the driver airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove the steering wheel.
(Refer to Steering System - "Steering Column and Shaft")
4.
Remove the steering wheel cover (A) after loosening the screw.

5.
Disconnect the steering heater connectors (A).

6.
Remove the steering remote control switch assembly after loosening the mounting screws (4EA).

7.
Disconnect the switch connectors (A).

8.
Remove the remote control switchs (A) after loosening the mounting screws.

Audio Remote Control Inspection
1. Check for resistance between terminals in each switch position. [Audio (LH)] Switch Connector terminal Resista ...

Audio Remote Control Installation
1. Reassemble the steering wheel remote control switch after connecting the connector. 2. Reassemble the driver airbag module. ...

See also:

Control Cable Removal
1. Remove the floor console assembly. (Refer to Body - " Floor Console") 2. Remove the select cable (B) by removing the snap ...

Cylinder Block Inspection
1. Remove gasket material. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Cl ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross V ...

Copyright © www.kifomanual.com 2014-2019