Kia Forte: Canister Close Valve (CCV) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV) Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the CCV connector.

3.	Measure resistance between the CCV terminal 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.	Disconnect the vapor hose connected with the canister from the CCV.

6.	Connect a vacuum pump to the nipple.

7.	Ground the CCV control line and apply battery voltage to the CCV power supply line.

8.

Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Canister Close Valve (CCV) Circuit Diagram

(M/T) (A/T) ...

Canister Close Valve (CCV) Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Dis ...

See also:

Front Stabilizer Bar Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Owner maintenance
The following lists are vehicle checks and inspections that should be performed by the owner or an authorized Kia dealer at the frequencies indicated to help ensure safe, dependable operation of you ...

Categories

Copyright © www.kifomanual.com 2014-2026