Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Airbag Module / Side Airbag (SAB) Module / Installation

Be sure to install the harness wires not to be pinched or interfered with other parts.

â€¢	Do not open the lid of the side airbag cover.

â€¢	Make sure that the airbag assembly cover is installed properly. Improper installation may prevent the proper deployment.

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

3.	Install the new seat back assembly.

4.	Install the front seat assembly. (Refer to Body - "Front seat assembly")

5.	Recline and slide the front seat forward fully, make sure the harness wires are not pinched of interfering with other parts.

6.	Reconnect the battery negative cable.

After installing the side airbag (SAB), confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal

The side airbag cannot be disassembled from the seat back assembly, so replace assembly when replacing the side airbag. ...

Curtain Airbag (CAB) Module

Curtain airbags are installed inside the headliner (LH and RH) and protect the driver and passenger from danger when side crash occurs. The SRSCM determines deployment of curtain airbag by us ...

Kia Forte: Installation

Removal

Curtain Airbag (CAB) Module

See also:

Categories