Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Seat Belt Pretensioner / Seat Belt Pretensioner (BPT) / Installation

1.	Remove the ignition key from the vehicle.

2.	Disconnect the battery negative cable and wait for at least thirty seconds.

Install the seat belt pretensioner with bolts (B).

Tightening torque

Bolt B:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the seat belt pretensioner connector (A).

Install the upper anchor bolt.

Tightening torque:

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

6.	Install the center pillar trim. (Refer to Body - "Center pillar trim")

7.	Install the door scuff trim. (Refer to Body - "Door scuff trim")

Insert the seat belt to the Emergency fastening device.

Make sure the lock pin is connected in properly.

9.	Reconnect the battery negative cable.

10.

After installing the seat belt pretensioner, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Removal

1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Emergency Fastening Device (EFD)

Front emergency fastening device operates as well as belt pretensioner at the same time If it gets into its deploy condition after a collision. It is located at near anchor on front seat and ...

Kia Forte: Installation

Removal

Emergency Fastening Device (EFD)

See also:

Categories