Kia Forte: Dynamic Damper Components

TJ Joint Installation

1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Dynamic Damper Replacement

1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft�) 2. Remove the TJ joint assembly. (Refe ...

See also:

Variable Charge Motion Actuator (VCMA) Inspection
1. Turn ignition switch OFF. 2. Disconnect the VCMA connector. 3. Check that the VCMA is not stuck by foreign ...

Inspection
W/Harness Inspection 1. Check the vehicle speed sensor by using the scan tool. (if normal, current vehicle speed is display) 2. Chec ...

Rear Spoiler Replacement
(5Door)    • When prying with a flat-tip screwdriver, wrap it with protectiv ...