Kia Forte: Parking Brake Cable Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Parking Brake System / Parking Brake Cable Removal
The parking brake cables must not be bent or distorted. This will
lead to stiff operation and premature failure.
|
| 1. |
Remove the floor console assembly.
(Refer to Body - "Floor console")
|
| 2. |
Disconnect the connector (A) of parking brake switch.
|
| 3. |
Remove the parking brake cable (B) after removing the cable retainer
(A).
|
| 4. |
Raise the vehicle, and make sure it is securely supported.
|
| 5. |
Remove the rear tire and wheel.
|
| 6. |
Remove the parking brake cable (B), after removing the clip (A).
|
| 7. |
Loosen the parking brake cable bracket bolts and remove the parking
brake cable (A).
|
Parking Brake Lever Adjustment
Parking Brake Lever Stroke Adjustment
1.
Remove the floor console.
(Refer to Body group - "Floor console")
2.
Apply the b ...
Parking Brake Cable Installation
1.
Install the parking brake cable (A).
Tightening torque :
8.8 ~ 14.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
...
See also:
Components
...
Front Strut Assembly Inspection
1.
Check the strut bearing for wear and damage.
2.
Check the spring upper and lower seat for damage and deterioration.
3.
...
Compressor Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the
engine.
The compressor changes low pressure and low temperatur ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026