Kia Forte: Emergency while driving - What to do in an emergency - Kia Forte TD 2014-2018 Owners ManualKia Forte: Emergency while driving

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Owners Manual / What to do in an emergency / Emergency while driving

In an emergency situation while the vehicle is in motion, you are able to turn the engine off and to the ACC position by pressing the ENGINE START/STOP button for more than 2 seconds or 3 times successively within 3 seconds. If the vehicle is still moving, you can restart the engine without depressing the brake pedal by pressing the ENGINE START/STOP button with the shift lever in the N (Neutral) position (if smart key equipped).

If the engine stalls at a crossroad or crossing

If the engine stalls at a crossroad or crossing, set the shift lever in the N (Neutral) position and then push the vehicle to a safe place.

If you have a flat tire while driving

If a tire goes flat while you are driving:

1.Take your foot off the accelerator pedal and let the vehicle slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull off the road as this may cause a loss of control. When the vehicle has slowed down to such a speed that it is safe to do so, brake carefully and pull off the road. Drive off the road as far as possible and park on a firm level ground. If you are on a divided highway, do not park in the median area between the two traffic lanes.

2.When the vehicle is stopped, turn on your emergency hazard flashers, set the parking brake and put the transaxle in P (automatic transaxle) or reverse (manual transaxle).

3.Have all passengers get out of the vehicle. Be sure they all get out on the side of the vehicle that is away from traffic.

4.When changing a flat tire, follow the instruction provided later in this section.

If engine stalls while driving

1.Reduce your speed gradually, keeping a straight line. Move cautiously off the road to a safe place.

2.Turn on your emergency flashers.

3.Try to start the engine again. If your vehicle will not start, contact an authorized Kia dealer or seek other qualified assistance.

If the engine will not start

If the engine doesn't turn over or turns over slowly

1.If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set.

2.Check the battery connections to be sure they are clean and tight.

3.Turn on the interior light. If the light dims or goes out when you operate the starter, the battery is discharged.

4.Check the starter connections to be sure they are securely tightened.

5.Do not push or pull the vehicle to start it. See instructions for "Jump starting".

WARNING - Push/ pull start

Do not push or pull the vehicle to start it. Push or pull starting may cause the catalytic converter to overload and create a fire hazard.

If engine turns over normally but does not start

1.Check fuel level.

2.With the ignition switch in the LOCK position, check all connectors at the ignition coil and spark plugs. Reconnect any that may be disconnected or loose.

3.Check the fuel line in the engine compartment.

4.If the engine still does not start, call an authorized Kia dealer or seek other qualified assistance.

Hazard warning flasher
The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle. It should be used whenever emergency repairs ar ...

Emergency starting
Connect cables in numerical order and disconnect in reverse order. Jump starting Jump starting can be dangerous if done incorrectly. Therefore, to avoid harm to yourself or damage to your vehic ...

See also:

Driver's and passenger's front air bag
Your vehicle is equipped with an Advanced Supplemental Restraint (Air Bag) System and lap/shoulder belts at both the driver and passenger seating position. The indications of the system's pr ...

Sunroof Motor Inspection
1. Disconnect the negative (-) battery terminal. 2. Remove the roof trim assembly. (Refer to Body - "Roof Trim Assembly") ...

35R Clutch Control Solenoid Valve(35R/C_VFS) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Copyright © www.kifomanual.com 2014-2024