Kia Forte: Engine Coolant Temperature Sensor (ECTS) Removal - Engine Control System - Engine Control / Fuel System - Kia Forte TD 2014-2018 Service ManualKia Forte: Engine Coolant Temperature Sensor (ECTS) Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the engine coolant temperature sensor connector (A).
3.
Remove the sensor (B).

  
Note that engine coolant may be flowed out from the water temperature control assembly when removing the sensor.
4.
Supplement the engine coolant (Refer to “Cooling System” in EM group).
Engine Coolant Temperature Sensor (ECTS) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the ECTS connector. 3. Remove the ECTS. 4. ...

Engine Coolant Temperature Sensor (ECTS) Installation
   • Install the component with the specified torques. • ...

See also:

PTC Heater Inspection
Operating Logic Test (Manual only) Inspect the PTC operation with the confirmation logic below : 1. Entering (1) Set the Floor mode ...

Inspection
1. Check the clutch release cylinder for fluid leakage. 2. Check the clutch release cylinder boot for damage. ...

Description
The immobilizer system will disable the vehicle unless the proper ignition key is used, in addition to the currently available anti-theft systems such as car alarms, the immobilizer system ai ...

Copyright � www.kifomanual.com 2014-2026