Kia Forte: Engine Coolant Temperature Sensor (ECTS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped.
|
|
| •
|
Apply the engine coolant to the O-ring.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage.
|
|
|
1. |
Install in the reverse order of removal.
Engine coolant temperature sensor
installation:
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
|
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the engine control system. If there
is no CKPS signal input, the engine may stop ...
See also:
Flat tire
For safe operation, carefully read and follow the instructions in this manual
before use.
(1) Compressor
(2) Sealant bottle
The Tire Mobility Kit is a temporary fix to the tire and the tire sh ...
Power Mosfet Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Disconnect the power mosfet connector (A) and then remove the
power mosfet (B) after lo ...
Thermostat Inspection
1.
Immerse the thermostat in water and gradually heat the water.
2.
Check the valve opening temperature.
If the valve opening te ...
Engine Coolant Temperature Sensor (ECTS) Removal
Crankshaft Position Sensor (CKPS) Description