Kia Forte: Parking Brake Lever Removal - Parking Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Parking Brake Lever Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Parking Brake System / Parking Brake Lever Removal

  
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Remove the floor console assembly.
(Refer to Body - "Floor console")
2.
Disconnect the connector (A) of parking brake switch.

3.
Remove the parking brake cable (B) after removing the cable retainer (A).

  
Parking brake lever in the car must be in fully loosened position.
4.
Remove the parking brake lever assembly (A) after removing the bolts.

Components
1. Parking brake lever 2. Parking brake cable 3. Equalizer assembly ...

Parking Brake Lever Installation
1. Install the parking brake lever assembly (A). Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...

See also:

Front Lower Arm Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Room lamp
To turn the room lamp ON or OFF, push the switch. If your vehicle is not equipped with a map lamp, the room lamp will also turn on or off as follows. The room lamp comes on when a door is opene ...

Injector Circuit Diagram
(M/T) (A/T) ...

Copyright www.kifomanual.com 2014-2026