Kia Forte: Adjustment
How To Initialize
|
1. |
Check that the glass has been installed.
| A. |
Finished height adjustment.
|
|
|
2. |
Push the UP switch. (Keep on pushing the switch)

|
|
3. |
Release the sunroof UP button with in 15 seconds. And then press
and hold the UP button once again within 15 seconds until the sunroof
do as follows.
| A. |
Tilt up → Slide Open → Slide Close
|
|
|
4. |
Then release the lever.
|
|
5. |
When the sunroof is closed completely, turn OFF the UP switch
initialize the motor completely.
|
When To Initialize The Motor
|
1. |
After initial vehicle assembly.
|
|
2. |
If the initial value is erased or damaged because of short power
electric discharge during operation.
|
|
3. |
After using the manual handle.
|
Operating The Sunroof Emergency Handle
|
1. |
Use the sunroof emergency handle to close or open the sunroof
manually if the sunroof cannot be closed electronically due to motor
or controller electrical malfunction.
|
|
2. |
Operating method.
| B. |
Push the emergency handle up into the hexagonal drive
(A) of the sunroof motor. You must push hard enough to disengage
the motor clutch; otherwise the emergency handle will slip due
to incomplete fit in the motor.
|
| C. |
Carefully turn the emergency handle clockwise to close
the sunroof.
|
| D. |
After closing the sunroof, wiggle the handle back and
forth as you remove the tool from the motor, to ensure the motor
clutch reengages.
|
| E. |
A 5mm hex socket may be used in place of the emergency
handle, with a” Speeder” type handle.
|
|
• |
Do not use power tools to operate the sunroof.
|
|
• |
Damage to the components may occur.
|
|

|
1. Glass panel assembly
2. Guide assembly
3. Drip rail assembly
4. Sunshade assembly
5. Deflector
6. Deflector link assembly
7. Sunroof frame assembly
8. Motor asse ...
See also:
Special driving conditions
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud,
sand, or similar hazards, follow these suggestions:
Drive cautiously and allow extra ...
Power Seat Control Switch Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the seat side cover (A).
3.
Disconnect the p ...
Rear Seat Belt Buckle Replacement
(4Door)
[LH]
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Loosen ...