Kia Forte: Rear Bumper Beam Assembly Replacement
| •
|
Put on gloves to protect your hands.
|
|
| •
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
| •
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
| •
|
Take care not to bend or scratch the trim and panels.
|
|
|
1. |
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
|
|
2. |
Disconnect the rear bumper beam mounting wiring harness (A).
|
|
3. |
After loosening the mounting clips, then remove the rear bumper
beam assembly (B).
|
|
4. |
Install in the reverse order of removal.
|
• |
Make sure the connector is plugged in properly.
|
|
• |
Replace any damaged clips.
|
|
|
(5Door)
| •
|
Put on gloves to protect your hands.
|
|
| •
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
| •
|
Use a plastic panel removal tool to remove interior trim
pieces to protect from marring the surface.
|
|
|
1. |
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
|
|
2. |
Remove the mounting clips, then remove the rear bumper beam assembly
(A).
|
|
3. |
Install in the reverse order of removal.
|
• |
Replace any damaged clips.
|
|
|
(4Door, 2Door)
1. Rear bumper beam assembly
(5Door)
1. Rear bumper beam assembly
...
See also:
Adjustment
Glass Adjustment
•
Check the glass run channel for damage or deterioration,
and re ...
Replacement
(4Door)
•
Put on gloves to protect your hands.
...
Fuel Pressure Regulator Removal
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender ...
Rear Bumper Beam Assembly Component Location
Front Seat