Kia Forte: Seat Heater Switch Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Seat Electrical / Seat Heater Switch Installation
Driver/Passenger Seat
| 1. |
Install the switchs and connect the switch connectors.
|
| 2. |
Insatll the floor console assembly.
|
| 3. |
Connect the negative (-) battery terminal.
|
Second Seat
| 1. |
Install the power window switch and connect the power window switch
connector.
|
| 2. |
Install the rear door trim panel.
|
| 3. |
Connect the negative (-) battery terminal.
|
Seat Heater Switch Removal
Driver/Passenger Seat
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - " ...
See also:
SRS Control Module (SRSCM)
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that does not. The ...
Heated Oxygen Sensor (HO2S) Installation
•
Install the component with the specified torques.
•
...
Windshield washers (front)
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wip ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026