1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. |
Disconnect the connector from the power window switch module.
|
4. |
Check for continuity between the terminals in each switch position
according to the table.
|
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. |
Disconnect the connector from the power window switch module.
|
4. |
Check the continuity between the terminals in each switch position
according the the table.
|
Operation
Evaporative System Monitoring
Evaporative And ORVR Emission Control System
This system consists of a fill vent valve, fuel shut-off valve, fuel cut
valve (for roll over), two way val ...
Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation
of the transaxle's turbine shaft and output shaft, and delivers the readings
to the Transaxle Control Module(TCM ...
Replacement
•
Be careful not to damage the fender and body.
...