Kia Forte: High Mounted Stop Lamp Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / High Mounted Stop Lamp Removal
[2 Door]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear roof trim.
(Refer to Body - "Roof Trim Assembly")
|
| 3. |
Disconnect the connector (A) from the high mounted stop lamp assembly.
|
| 4. |
Remove the high mounted stop lamp assembly (A) after loosening
the mounting bolts.
|
[4 Door]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear package tray trim.
(Refer to Body - "Rear Package Tray Trim")
|
| 3. |
Remove the high mounted stop lamp assembly (A) after loosening
the screws.
|
[5 Door]
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear spoiler.
(Refer to Body - "Rear Spoiler)
|
| 3. |
Remove the high mounted stop lamp (A) after loosening the mounting
screws.
|
Front Fog Lamps Installation
1.
Install the front fog bulb.
2.
Reconnect the lamp connector.
3.
Install the front bumper cover.
...
High Mounted Stop Lamp Installation
[2 Door]
1.
Install the high mounted stop lamp assembly.
2.
Install the roof trim assembly.
[4 Door]
1.
...
See also:
Component Location
[Engine Room]
1. Receiver Drier
2. Condenser
3. Ambient Temperature Sensor
4. Compressor
5. Discharge Hose
6. Suction & Liquid Tube Assembly
7. Servic ...
Sub Frame Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A ...
Steering Angle Sensor
The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power
Steering) and it sends messages to HECU through CAN communication line.
The SAS is used to determine turning directio ...
Copyright © www.kifomanual.com 2014-2025