1. |
Measure the pressure of high pressure line by measuring voltage
output between NO.1 and NO.2 terminals.
|
2. |
Inspect the voltage value whether it is sufficient to be regular
value or not.
|
3. |
If the measured voltage value is not within specification, replace
the A/C pressure transducer.
|
Rear Door Belt Inside Weatherstrip Replacement
(4Door, 5Door)
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door bel ...
Alternator Circuit Diagram
•
COM signal - When
controlling the voltage generated, the ECM sends the target
...
Smart Key Unit Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the main crash pad assembly.
(Refer to Body - "Main C ...