Kia Forte: Starter Cleaning
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Starting System / Starter Cleaning
| 1. |
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation
wipe these parts with a cloth only.
|
| 2. |
Do not immerse the drive unit in cleaning solvent.
The overrun clutch is pre-lubricated at the factory and sol-vent
will wash lubrication from the clutch.
|
| 3. |
The drive unit may be cleaned with a brush moistened with cleaning
solvent and wiped dry with a cloth.
|
Starter Inspection
Starter Solenoid Inspection
1.
Disconnect the lead wire from the M-terminal of solenoid switch.
2.
Connect the battery as shown. If ...
Starter Relay Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay (A).
...
See also:
Tire Installation
1.
Apply tire soap or lubrication to the top and bottom tire beads.
2.
To fit the bottom bead, position the valve at the 5 o’clock pos ...
Rear Seat Assembly Replacement
[Rear seat cushion assembly]
1.
Disconnect the rear seat cushion heater connector (A) from the
trunk inner side.
2.
After loosening th ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026