Kia Optima Manuals

Kia Forte: Rear Seat Assembly Replacement - Rear Seat - Body (Interior and Exterior) - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Seat Assembly Replacement

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body (Interior and Exterior) / Rear Seat / Rear Seat Assembly Replacement

[Rear seat cushion assembly]
1.
Disconnect the rear seat cushion heater connector (A) from the trunk inner side.
2.
After loosening the mounting bolts and then push it up and remove the rear seat cushion assembly (B).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~18.8 lb-ft)

3.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
[Rear seat back assembly]
(4Door, 2Door)
1.
Remove the rear seat cushion assembly.
2.
Fold the rear seat back assembly.
3.
After loosening the mounting bolts, then remove the rear seat back assembly (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~18.8 lb-ft)

4.
Install in the reverse order of removal.
(5Door)
1.
Remove the rear seat cushion assembly.
2.
Using a flat-tip screwdriver, push the locking pin (B) and then remove the mini buckle (A).
3.
Fold the rear seat back assembly.
4.
After loosening the mounting bolts, then remove the rear seat back assembly (A).
Tightening torque :
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~18.8 lb-ft)

5.
Install in the reverse order of removal.
Rear Seat Assembly Component Location
(4Door, 2Door) 1. Rear seat cushion assembly 2. Rear seat back assembly (5Door) 1. Rear seat back assembly [LH] 2. Rear seat back ...

Rear Seat Back Cover Component Location
(4Door, 2Door) 1. Rear seat back cover [LH] 2. Rear seat back cover [RH] (5Door) 1. Rear seat back assembly [LH] 2. Rear seat ...

See also:

Evaporator Temperature Sensor Replacement
1. Disconnect the negative (-) battery terminal. 2. Disconnect the evaporator temperature sensor connector (A). 3. ...

CVVT Oil Control Valve (OCV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the CVVT oil control valve connector (A). ...

Air Ventilation Seat Unit Description
The ventilated seat system uses a Push method to cool the seat. A blower mounted in the seat generates the cool air, which then travels through ducts to the seat back and cushion. ...

Categories

Copyright www.kifomanual.com 2014-2026