Kia Forte: Canister Close Valve (CCV) Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Canister Close Valve (CCV) Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the CCV connector.

3.	Measure resistance between the CCV terminal 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to "Specification"

5.	Disconnect the vapor hose connected with the canister from the CCV.

6.	Connect a vacuum pump to the nipple.

7.	Ground the CCV control line and apply battery voltage to the CCV power supply line.

8.

Apply vacuum and check the valve operation.

Specification: Vacuum maintained

Canister Close Valve (CCV) Circuit Diagram

(M/T) (A/T) ...

Canister Close Valve (CCV) Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Dis ...

See also:

Drive Belt Tensioner Removal and Installation
1. Remove the drive belt. (Refer to Timing System - "Drive Belt") 2. Remove the alternator lower bolt (A). ...

Brake Booster Vacuum Pressure Sensor Description
In order to ensure adequate brake power assistance in every situation, the brake booster is equipped with a partial vacuum sensor. The brake booster vacuum pressure sensor is located beside t ...

[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...

Categories

Copyright © www.kifomanual.com 2014-2026