Brake Booster Vacuum Pressure Sensor can not be replaced separately
due to vacuum leak.
Therefore, the sensor must be replaced with an assembly with the
brake booster.
(Refer to Brake System - Brake Booster)
|
Overhead Console Lamp Inspection
1.
Remove the overhead console lamp assembly then check for continuity
between terminals. If the continuity is not as specified, replace the
map lamp switch.
...
Knock Sensor (KS) Description
Knocking is a phenomenon characterized by undesirable vibration and noise
and can cause engine damage. Knock Sensor (KS) is installed on the cylinder
block and senses engine knocking.
Whe ...
Audio Remote Control Installation
1.
Reassemble the steering wheel remote control switch after connecting
the connector.
2.
Reassemble the driver airbag module.
...