Kia Forte: Installation
|
1. |
Install in the reverse order of removal.
|
|
If the oil seal on the transaxle case side is damaged and fluid
is leaking, replace the oil seal with a new unit. When installing the
new oil seal, use the specialized tool (oil seal installer, 09452-26100).
|
|
After replacement or reinstallation procedure of the automatic
transaxle assembly, must perform procedures below.
| •
|
Adding automatic transaxle fluid.
(Refer to Hydraulic System - "Fluid")
|
| •
|
After replacing the automatic transaxle, clear the Diagnostic
Trouble Code(DTC) using the GDS tool. DTC cannot be cleared
by disconnecting the battery.
|
| •
|
When replacing the automatic transaxle, reset the automatic
transaxle's values by using the GDS.
|
| •
|
Perform TCM learning after replacing the transaxle to
prevent slow transaxle response, jerky acceleration and jerky
startup.
(Refer to Automatic Transaxle Control System - "Repair
procedures")
|
|
1.
Engine cover.
(Refer to Engine Mechanical System - "Engine cover")
2.
Air cleaner assembly and air duct.
(Refe ...
See also:
Battery Sensor Installation
1.
Install in the reverse order of removal.
Battery sensor cable installation
bolt: 10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~10.1
lb-ft)
...
Radiator Inspection
Radiator Cap Testing
1.
Remove the radiator cap, wet its seal with engine coolant, and
then install it on a pressure tester.
2.
...
Front Wiper Motor Inspection
Speed Operation Check
1.
Remove the connector (A) from the wiper motor.
2.
Attach the positive (+) lead from the battery to terminal ...
Removal
Hydraulic System