Kia Forte: Dynamic Damper Components - Driveshaft Assembly - Driveshaft and axle - Kia Forte TD 2014-2018 Service ManualKia Forte: Dynamic Damper Components

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Components

1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ case
13. Circlip

TJ Joint Installation
1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boot. 2. Using the alignment marks (D) made during disassembly as a ...

Dynamic Damper Replacement
1. Remove the front driveshaft. (Refer to Driveshaft Assembly - “Front Driveshaft”) 2. Remove the TJ joint assembly. (Refe ...

See also:

Special driving conditions
Hazardous driving conditions When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra ...

Components Location
1. AVN (A/V & Navigation head unit) 2. Tweeter speaker 3. Glass antenna amp (Radio) 4. Front door speaker 5. Rear door speaker 6. Antenna feeder cable jiont 7. Ant ...

Cigarette lighter (if equipped)
For the cigarette lighter to work, the ignition switch must be in the ACC or ON position. To use the cigarette lighter, push it all the way into its socket. When the element is heated, the ligh ...

Copyright www.kifomanual.com 2014-2026