Kia Forte: Dynamic Damper Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Driveshaft and axle / Driveshaft Assembly / Dynamic Damper Installation
| 1. |
Apply soap powder on the shaft to prevent being damaged between
the shaft spline and the dynamic damper.
|
| 2. |
Install the dynamic damper.
|
| 3. |
Install the dynamic damper band (A).
|
| 4. |
Using the SST(09495-3K000), secure the TJ boot bands (B).
|
| 5. |
Install the TJ joint assembly.
(Refer to Driveshaft Assembly - “TJ Joint”)
|
| 6. |
Install the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
|
| 7. |
Check the front alignment.
(Refer to Suspension System - "Front Alignment")
|
Dynamic Damper Replacement
1.
Remove the front driveshaft.
(Refer to Driveshaft Assembly - “Front Driveshaft”)
2.
Remove the TJ joint assembly.
(Refe ...
BJ Boot Components
1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
1 ...
See also:
SS-B Solenoid Valve(ON/OFF) Description
Shift Solenoid(SS) Valve-B is attached to the valve body and is an on/off
solenoid valve that is used to change gears. Shift Solenoid(SS) Valve-B is installed
at valve body.
...
AGM Battery Inspection
Battery Diagnostic Flow
Vehicle parasitic current inspection
1.
Turn all the electric devices OFF, and then turn the ignition
switch OFF.
...
Cylinder Block Disassembly
•
Use fender covers to avoid damaging painted surfaces.
...
Copyright www.kifomanual.com 2014-2025