1. |
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Remove the rear shock absorber (A) from the frame by loosening
the bolt.
|
4. |
Loosen the bolt & nut and then remove the rear shock absorber
(A) from the torsion beam axle.
|
5. |
Installation is the reverse of removal.
|
6. |
Check the rear alignment.
(Refer to Rear Suspension System - "Rear Alignment")
|
Compressor Components
1. Center Bolt
2. Hub Bolt
3. Disc & Hub Assembly
4. Snap Ring
5. Pulley
6. Compressor Assembly
7. Electric Control Valve (ECV)
...
Parking Brake Lever Installation
1.
Install the parking brake lever assembly (A).
Tightening torque :
19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft)
...
Installation
1.
Install in the reverse order of removal.
2.
After be equipped, perform bleeding air procedure in clutch release
cylinder after pouring t ...