Kia Optima Manuals

Kia Forte: Rear Wheel Speed Sensor Removal - ESC(Electronic Stability Control) System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Wheel Speed Sensor Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / ESC(Electronic Stability Control) System / Rear Wheel Speed Sensor Removal

1.
Remove the rear wheel and tire.
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
2.
Remove the rear wheel speed sensor mounting bolt (A).
Tightening torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

3.
Remove the rear wheel speed sensor cable mounting bolt.
4.
Remove the rear wheel house trim.
(Refer to Body - "Rear wheel house trim")
5.
Disconnect the rear wheel speed sensor connector and than remove the rear wheel speed sensor.
6.
Install in the reverse order of removal.
  
Install the rear sensor after lubricating the O-ring of sensor with the assembly fluid(RAREMAX AF-1)
When inserting the sensor, take care the O-ring not to be damaged.
Rear Wheel Speed Sensor Components
1. Rear wheel speed sensor 2. Rear wheel speed sensor connector ...

Yaw-rate and Lateral G Sensor
When the vehicle is turning with respect to a vertical axis the yaw rate sensor detects the yaw rate electronically by the vibration change of plate fork inside the yaw rate sensor. If ya ...

See also:

Input Speed Sensor Circuit Diagram
...

Steering Column Shroud Panel Component Location
1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

Installation
1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring ...

Categories

Copyright www.kifomanual.com 2014-2026