Kia Forte: Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 4. |
Remove the rear air vent duct (A).
|
| 5. |
Pull up the lock, of the SRSCM connector, the disconnect the connector
(A).
|
| 6. |
Remove the SRSCM mounting bolt and nuts from the SRSCM, then remove
the SRSCM.
|
Components
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
Alternator On-vehicle Inpection
•
Check that the battery cables are connected to the correct
terminals.
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Low Panal")
...
Seat Belt Buckle Sensor (BS)
The SRSCM shall monitor the status of the driver and passenger seat belt
buckle. The SRSCM provides one pin each for the driver and passenger seat belt
buckle status input. The seat belt buck ...
Copyright © www.kifomanual.com 2014-2025