Kia Forte: Manifold Absolute Pressure Sensor (MAPS) Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Manifold Absolute Pressure Sensor (MAPS) Removal
| 1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
| 2. |
Disconnect the manifold absolute pressure sensor connector (A).
|
| 3. |
Remove the installation bolt (B), and then remove the sensor from
the surge tank.
|
Manifold Absolute Pressure Sensor (MAPS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the MAPS at idle and IG ON.
Conditio ...
Manifold Absolute Pressure Sensor (MAPS) Installation
•
Install the component with the specified torques.
•
...
See also:
Smart Key Unit Component
Component (1)
Connector Pin Information
No.
Connector A (24 pins)
No.
Connector B (20 pins)
No.
Connector C (18 pins)
1
VBAT CPU
...
Installation
•
Install the concentric slave cylinder bolts. Not to be
bent or twisted, Tighten them ...
Components
[M/T]
1. Floor console assembly
2. Console upper cover
3. Console tray
4. Console armrest met
5. Rear console cover
6. Rear console airvent
7. Console du ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright � www.kifomanual.com 2014-2026