Kia Forte: Installation - Concentric Slave Cylinder Assembly - Clutch System - Kia Forte TD 2014-2019 Service ManualKia Forte: Installation

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Clutch System / Concentric Slave Cylinder Assembly / Installation

  
Х
Install the concentric slave cylinder bolts. Not to be bent or twisted, Tighten them in diagonal directions.
Х
When it is assembled, it must be free from invasive foreign matters and oil leakage.
1.
Installation is in reverse order of removal.
2.
Perform bleeding air procedure in concentric slave cylinder after pouring the brake fluid.
(Refer to Concentric Slave Cylinder Assembly - "Adjustment")
Removal
1. Remove the transaxle assembly. (Refer to Manual Transaxle System - " Manual Transaxle") 2. Remove the concentric slave cyl ...

Adjustment
Concentric Slave Cylinder Air Bleeding Procedure 1. After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the pl ...

See also:

Center Pillar Trim Replacement
[Center pillar lower trim] (4Door, 5Door)    Х Put on gloves to protect your hand ...

Front Seat Frame Assembly Component Location
1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Copyright © www.kifomanual.com 2014-2019