Kia Optima Manuals

Kia Forte: Installation - Side Impact Sensor (SIS) - SRSCM - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) / Installation

Pressure Side Impact Sensor
1.
Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A).
Tightening torque :
3.0 ~ 4.0 N.m (0.31 ~ 0.41 kgf.m, 2.2 ~ 2.9 lb-ft)

  
•
Use the specified screws surely.
2.
Install the front door trim.
(Refer to Body - "Front door trim")
3.
Reconnect the battery negative cable.
4.
After installing the pressure side impact sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
  
•
You must comply with the specified tightening torques with the tool specified because Pressure – Side Impact Sensors (P-SIS) may be broken or POP-NUT may be rotated.
•
Problems may be occurred in the durability of P-SIS or impact sensing performance may be depreciated if POP-NUT is rotated.
•
The door module must not be transformed because SRSCM judges a impact through the pressure sensor in the door module.
Side Impact Sensor
  
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.
1.
Install the new side impact sensor (B) with the bolt then connect the side impact sensor connector (A).
Tightening torque:
8.0 ~ 10.0 N.m (0.82 ~ 1.02 kgf.m, 5.9 ~ 7.4 lb-ft)

2.
Install the center pillar lower trim.
(Refer to Body - "Center pillar trim")
3.
Install the door scuff trim.
(Refer to Body - "Door scuff trim")
4.
Reconnect the battery negative cable.
5.
After installing the Side Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
Pressure Side Impact Sensor    • Removal of the airbag must be performed according ...

Seat Belt Buckle Sensor (BS)
The SRSCM shall monitor the status of the driver and passenger seat belt buckle. The SRSCM provides one pin each for the driver and passenger seat belt buckle status input. The seat belt buck ...

See also:

Alternator On-vehicle Inpection
   • Check that the battery cables are connected to the correct terminals. ...

Rear Seat Assembly Replacement
[Rear seat cushion assembly] 1. Disconnect the rear seat cushion heater connector (A) from the trunk inner side. 2. After loosening th ...

Starter Description
The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...

Categories

Copyright www.kifomanual.com 2014-2026