Kia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / SRSCM / Side Impact Sensor (SIS) / Removal

Pressure Side Impact Sensor

•	Removal of the airbag must be performed according to the precautions/procedures described previously.

•	Before disconnecting the side impact sensor connector(s), disconnect the side airbag connector(s).

•	Do not turn the ignition switch ON and do not connect the battery cable while replacing the side impact sensor.

1.	Disconnect the battery negative cable, and wait for at least three minutes before beginning work.

2.	Remove the front door trim. (Refer to Body - "Front door trim")

3.	Disconnect the pressure side impact sensor connector (A).

4.	Loosen the pressure side impact sensor mounting screws (B) and then remove the pressure side impact sensor.

Side Impact Sensor

1.	Disconnect the battery negative cable and wait for at least three minutes before beginning work.

2.	Remove the door scuff trim. (Refer to Body - "Door scuff trim")

3.	Remove the center pillar lower trim. (Refer to Body - "Center pillar trim")

4.	Disconnect the side impact sensor connector (A).

5.	Loosen the side impact sensor mounting bolt and then remove the side impact sensor (B).

Components

...

Installation

Pressure Side Impact Sensor 1. Install the new pressure side impact sensor with the screws (B) then connect the pressure side impact sensor connector (A). ...

See also:

Power Seat Control Switch Inspection
1. With the power seat switch in each position, make sure that continuity exists between the terminals below. If continuity is not as specified, replace the power seat ...

Fuel Sender Removal
1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") 2. Disconnect the electric pump wiring connector (A) and t ...

Climate Control Air Filter Replacement
1. Disconnect the stopper (B) from the glove box (A). 2. Disconnect the air damper (A) from the glove box (B). ...

Categories

Copyright � www.kifomanual.com 2014-2026