Kia Forte: Front Hub / Knuckle Reassembly - Front Axle Assembly - Driveshaft and axle - Kia Forte TD 2014-2019 Service ManualKia Forte: Front Hub / Knuckle Reassembly

Second generation YD (2014-2019) / Kia Forte TD 2014-2019 Service Manual / Driveshaft and axle / Front Axle Assembly / Front Hub / Knuckle Reassembly

1.
Install the hub bearing to the knuckle assembly.
(1)
Lay the knuckle assembly (A) on press.
(2)
Lay a new hub bearing upon the knuckle assembly (A).
(3)
Lay a suitable adapter (B) upon the hub bearing.
(4)
Install the hub bearing to the knuckle assembly by using press.

  
-
Do not press against the inner race of the hub bearing because that can cause damage to the bearing assembly.
-
Always use a new wheel bearing assembly.
2.
Install the hub assembly to the knuckle assembly.
(1)
Lay the hub assembly (A) upon a suitable adapter .
(2)
Lay the knuckle assembly (B) upon the hub assembly (A).
(3)
Lay a suitable adapter (C) upon the hub bearing.
(4)
Install the hub assembly (A) to the knuckle assembly (B) by using press.

  
Do not press against the inner race of the hub bearing because that can cause damage to the bearing assembly.
3.
Install the snap ring (A).

Front Hub / Knuckle Disassembly
1. Remove the snap ring (A). 2. Remove the hub assembly from the knuckle assembly. (1) Install the ...

Front Hub / Knuckle Inspection
1. Check the hub for cracks and the splines for wear. 2. Check the brake disc for scoring and damage. 3. C ...

See also:

Fuel Line Removal
1. Release the residual pressure in fuel line. (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line".) ...

Positive Crankcase Ventilation (PCV) Valve Operation Principle
...

Sub Frame Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Copyright © www.kifomanual.com 2014-2019