Kia Forte: Front Washer Motor Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Washer Motor Removal

-	When servicing the washer pump, be careful not to damage the washer pump seal.

-	Do not operate the washer pump before filling the washer reservoir. Failure to do so could result in premature pump failure.

1.	Disconnect the negative (-) battery terminal.

2.	Remove the front bumper cover. (Refer to Body - "Front Bumper Cover")

3.	Remove the washer hose and disconnect the washer motor connector (A).

4.	Remove the washer reservoir after loosening bolts and screw.

Front Washer Motor Inspection

1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. ...

Front Washer Motor Installation

1. Install the washer reservoir. Before installing the pump motor, check ...

See also:

Warning Messages
Shift to "P" position (for smart key system and automatic transaxle) This warning message illuminates if you try to turn off the engine without the shift lever in P (Park) position ...

Spark Plug Removal
1. Remove the ignition coil. (Refer to Ignition System - "Ignition Coil") 2. Using a spark plug wrench, remove the spark plu ...

Fuel requirements
Your new Kia vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performan ...

Categories

Copyright © www.kifomanual.com 2014-2026