Kia Forte: Fuel Tank Pressure Sensor (FTPS) Installation
| •
|
Install the component with the specified torques.
|
| •
|
Note that internal damage may occur when the component
is dropped. In this case, use it after inspecting.
|
|
| •
|
Insert the sensor in the installation hole and be careful
not to damage when installation.
|
|
|
1. |
Install in the reverse order of removal.
|
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the rear seat.
(Refer to Body - “Rear Se ...
Based on information from various sensors, the ECM can calculate the fuel
amount to be injected. The fuel injector is a solenoid-operated valve and the
fuel injection amount is controlled by ...
See also:
Fuel Pump Removal
[LEV2]
1.
Release the residual pressure in fuel line (Refer to the Fuel
Delivery System - Repair Procedures - "Release Residual Pressure in
Fuel Line ...
Center Fascia Panel Component Location
1. Center fascia panel
...
Blower Resistor Inspection
1.
Measure terminal-to-terminal resistance of the blower resistor.
2.
If the measured resistance is not within specification, the blower
re ...
Fuel Tank Pressure Sensor (FTPS) Removal
Injector Description