Kia Forte: Hazard Lamp Switch Removal - Lighting System - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Hazard Lamp Switch Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Lighting System / Hazard Lamp Switch Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
3.
Remove the hazard switch (A) after loosening the screws.

License Lamp Installation
1. Connect the connector. 2. Install the license lamp. ...

Hazard Lamp Switch Installation
1. Install the hazard switch. 2. Install the center fascia panel. ...

See also:

ECM Terminal And Input/Output signal (A/T)
ECM Terminal Function Connector [CNG-AA] Pin No. Description Connected to 1 Ignition Coil (Cylinder #2) control output Ignition Co ...

Rear Pillar Trim Component Location
(4Door) 1. Rear pillar trim (5Door) 1. Rear pillar trim (2Door) 1. Rear pillar trim ...

Multimedia Jack Installation
1. Install the multimedia jack. 2. Connect the multimedia jack connector. 3. Install the floor console assembly ...

Copyright www.kifomanual.com 2014-2026