Kia Forte: Hood Assembly Replacement
| •
|
Be careful not to damage the hood and body.
|
|
| •
|
When removing and installing the hood, an assistant is
necessary.
|
| •
|
When removing the clips, use a clip remover.
|
|
|
1. |
After loosening the hood hinge (B) mounting bolts, remove the
hood assembly (A).
Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)
|
|
|
2. |
Install in the reverse order of removal.
|
• |
Make sure the hood locks/unlocks and opens/closes
properly.
|
|
• |
Adjust the hood alignment.
|
|
|
1.
Using a clip remover, detach the clips, and remove the hood insulator
pad (A).
...
See also:
SRS Care
The SRS is virtually maintenance-free and there are no parts you can safely service
by yourself. If the SRS air bag warning light does not illuminate, or continuously
remains on, have your vehicle i ...
Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary.
Plain water may be used if washer fluid is not available.
However, use washer solvent with antifreeze characterist ...
ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function
Connector [CNG-MA]
Pin No.
Description
Connected to
1
Ignition Coil (Cylinder #1) control output
Ignition Co ...
Hood Assembly Component Location
Hood Insulator Pad Replacement